Cast iron wood stove set in a tiled corner hearth with its black stove pipe running up the wall
Corner install on a tiled hearth, Enterprise neighborhood, Redding

Wood stoves, inserts and pellet stoves in Shasta County

Steady wood heat, installed right the first time

Dale and Wes Hollister size, permit and install wood stoves and fireplace inserts across Redding and the foothills. One crew, one day on site for most jobs, and a stove that keeps the whole house warm through January.

Installer on a roof fitting a stainless steel chimney pipe through new flashing

"They ran a new liner up our old chimney, set the insert and were sweeping up by 3 o'clock. Our heating bill dropped by half."

Marcy T., Palo Cedro
4.9from 176 Google reviews
1,100+stoves installed since 2009
NFIcertified woodburning specialist
CA Lic.#1023476, fully insured

What we install, and what it costs

Installed prices include the unit, hearth or liner, chimney parts, the permit and haul-away of your old stove. You get a fixed written price after the home visit.

Cream enamel wood stove on a slate pad in a shiplap living room, with a tall black stove pipe
Freestanding stove with a through-the-ceiling Class A chimney
InstallIncludedInstalled price
Freestanding wood stoveEPA 2020 stove, hearth pad, Class A chimney, permit$4,200–$7,800
Wood insert in your fireplaceInsert, full stainless liner, surround panel, permit$3,800–$6,500
Pellet stoveStove, direct vent kit, outlet check, first bag of pellets$3,900–$5,800
Chimney reline6" stainless liner, top cap, smoke test$1,900–$3,400
Install your own stovePipe, chimney kit and labor for a stove you already own$1,450–$2,600
Sweep and inspectionBrush, gasket check, written Level 1 report$219

Most installs are one day. Second-story or steep-roof chimneys can add $300–$700; we tell you at the visit, not on the bill.

How big a stove does your house need?

Too small and it runs flat out all night. Too big and you choke it down, which makes creosote. Move the sliders for a rough size; we confirm it with a tape measure at the visit.

  • Based on the BTU figures we use for Redding winters (design temp about 29°F).
  • Foothill homes above 2,000 ft: pick one step colder.
How well is the house sealed?
Floor plan
Heat needed43,200 BTU/hr
SmallMediumLarge

Medium stove, 2.0 to 2.5 cu ft firebox. Installed from about $4,900 to $6,600.

What a winter of heat costs here

Rough season cost to heat a 1,800 sq ft Redding home, November to March, at this fall's local prices. Your numbers will move with how you burn, but the order rarely changes.

Split oak firewood stacked tight with the cut ends facing out
Seasoned oak: about $360 a cord delivered in Shasta County
Ladder leaning against a stone chimney on a shingle roof under a blue sky
We check the chimney from the roof before we quote a liner

From first call to first fire

  1. 1

    Home visit, free

    About 45 minutes. We measure clearances, look up the chimney and talk about how you live in the house.

  2. 2

    Pick a stove, get a fixed price

    Two or three stoves that fit, with the installed price written next to each. No pressure, no showroom.

  3. 3

    Permit

    We pull the City of Redding or Shasta County permit. Usually 5 to 10 business days.

  4. 4

    Install day

    Drop cloths down by 8. Stove set, chimney run, roof sealed and the room vacuumed by late afternoon.

  5. 5

    Inspection and first burn

    We meet the inspector, then light the first fire with you and show you how to run it low and clean.

Dale Hollister, gray-haired in glasses and a flannel shirt, sitting at his workbench
Dale Hollister in the shop on Churn Creek Road

A father and son who still answer the phone

Dale started installing stoves in 2009, after twenty years as a framing carpenter around Redding. His son Wes joined in 2016 and now runs most installs. There are four of us: Dale, Wes, an apprentice and Linda in the office.

We sell and install a short list of stoves we would put in our own homes, and we service what we install. If something smokes or a gasket goes, you call the same number and one of us comes out.

Since
2009
Crew
4 people, 2 trucks
Warranty
5 years on labor

Dale & Wes Hollister

What neighbors say

4.9 average from 176 Google reviews

"Our 1978 Fisher was a smoke machine. Wes talked us into a smaller stove than we asked for and he was right. It holds a fire all night and the back bedrooms are finally warm."

Gary L., Shasta Lake

"Dale came out the day after I called, found a cracked flue tile and showed me photos. The reline and the insert came in $200 under the estimate."

Teresa M., Anderson

"We lost power for three days in the February storm and the pellet stove ran off a small generator the whole time. Install was clean, they even patched the siding."

Rob and Kim D., Shingletown

Where we work

Redding and the towns within about an hour. Home visits are free everywhere on this list; the farther towns carry a small trip fee on the install.

Shop: 1875 Churn Creek Rd, Redding, CA 96002
Mon–Fri 8 to 5, Sat 9 to 1 (October to March)

Black cast iron wood stove on a brick hearth with split firewood stacked beside it
Insert-to-stove swap in a 1950s ranch house, Anderson
TownDriveTrip fee
ReddingHome baseNone
Anderson, Cottonwood15–25 minNone
Shasta Lake, Palo Cedro15–20 minNone
Bella Vista, Millville25 minNone
Shingletown, Igo, Ono35–40 min$45
Red Bluff, Lakehead40 min$60
Burney, Fall River Mills60–75 min$95

Questions we hear every fall

How far ahead should I book?

For install before Thanksgiving, call by mid-September. From October on we usually run 3 to 5 weeks out, mostly because of permits and stove stock.

Can you put an insert in my old fireplace?

Usually, yes. Most masonry fireplaces in Redding take an insert with a full stainless liner. If the firebox or chimney is cracked we show you and price the repair separately.

Do I need a permit for a wood stove?

Yes, in the city and the county. We pull it, pay it (it is in your price) and meet the inspector, so you do not have to take a day off.

Wood or pellet: which is better?

Wood is cheaper to run and works without power. Pellets are easier: fill the hopper once a day and set a thermostat. If you are away all day, pellets usually win.

Will it pass the EPA and burn-day rules?

Every stove we sell meets the EPA 2020 standard. Shasta County still has curtailment days, and certified stoves are allowed on most of them.

Do you install stoves bought online?

Yes, as long as it is UL listed and new. We charge for the chimney kit and labor only, from $1,450.

Rather talk it through? Dale picks up most weekdays before 8 and after 4.

Call (530) 555-0142

Book a free home visit

Tell us a little about the house. Wes or Linda calls you back within one business day to set a time.

Call (530) 555-0142 Book a visit